Compound Mitre Saw
1. Operate only with instructor’s permission and after you have received instruction.
2. Remove any jewelry, eliminate loose clothing, and confine long hair.
3. Make sure all guards are in place and operating correctly.
4. Always use proper eye protection.
5. All materials should be inspected for defects such as warps, knots and foreign objects.
6. Make all blade changes and angle adjustments with the power supply to the Compound Miter Saw disconnected.
7. Install clean, sharp, cross-cut type blades only in the Compound miter saw.
8. Make sure the rotation of the blade is such that the teeth at the cutting edge rotate towards the fence.
9. Install a new table kerf plate if the current one is damaged or excessively cut.
10. Hold the stock firmly against the fence and the table keeping your fingers at least 6”away from the blade.
11. Allow the blade to rev up to full operating speed before letting the blade enter into the stock.
12. When finished turn off the Compound Miter Saw and wait for the blade to come to a complete stop before retracting from the work piece.
13. Disconnect the Compound Miter Saw from the power source before beginning clean-up procedures.
2. Remove any jewelry, eliminate loose clothing, and confine long hair.
3. Make sure all guards are in place and operating correctly.
4. Always use proper eye protection.
5. All materials should be inspected for defects such as warps, knots and foreign objects.
6. Make all blade changes and angle adjustments with the power supply to the Compound Miter Saw disconnected.
7. Install clean, sharp, cross-cut type blades only in the Compound miter saw.
8. Make sure the rotation of the blade is such that the teeth at the cutting edge rotate towards the fence.
9. Install a new table kerf plate if the current one is damaged or excessively cut.
10. Hold the stock firmly against the fence and the table keeping your fingers at least 6”away from the blade.
11. Allow the blade to rev up to full operating speed before letting the blade enter into the stock.
12. When finished turn off the Compound Miter Saw and wait for the blade to come to a complete stop before retracting from the work piece.
13. Disconnect the Compound Miter Saw from the power source before beginning clean-up procedures.